MX25L25635FMI-10G Memory by Macronix

Description MX25L25635F is 256Mb bits serial Flash memory, which is configured as 33,554,432 x 8 internally. When it is in two or four I/O mode, the structure becomes 134,217,728 bits x 2 or 67,108,864 bits x 4. MX25L25635F feature a serial peripheral interface and software protocol allowing operation on a simple 3-wire bus while it is in single I/O mode.
The three bus signals are a clock input (SCLK), a serial data input (SI), and a serial data output (SO). Serial access to the device is enabled by CS# input.
Features GENERAL
• Serial Peripheral Interface compatible -- Mode 0 and Mode 3
• Single Power Supply Operation - 2.7 to 3.6 volt for read, erase, and program operations
• 256Mb: 268,435,456 x 1 bit structure or 134,217,728 x 2 bits (two I/O mode) structure or 67,108,864 x 4 bits (four I/O mode) structure
• Protocol Support - Single I/O, Dual I/O and Quad I/O
• Latch-up protected to 100mA from -1V to Vcc +1V
• Low Vcc write inhibit is from 2.3V to 2.5V
• Fast read for SPI mode- Support clock frequency up to 133MHz for all protocols- Support Fast Read, 2READ, DREAD, 4READ, QREAD instructions.- Configurable dummy cycle number for fast read operation
• Quad Peripheral Interface (QPI) available
• Equal Sectors with 4K byte each, or Equal Blocks with 32K byte each or Equal Blocks with 64K byte each- Any Block can be erased individually
• Programming :- 256byte page buffer- Quad Input/Output page program(4PP) to enhance program performance
• Typical 100,000 erase/program cycles
• 20 years data retention SOFTWARE
FEATURES
• Input Data Format - 1-byte Command code
• Advanced Security
Features- Block lock protection
The BP0-BP3 and T/B status bits define the size of the area to be protected against program and erase instructions- Advanced sector protection function (Solid and Password Protect)
• Additional 4K bit security OTP -
Features unique identifier - factory locked identifiable, and customer lockable
• Command Reset
• Program/Erase Suspend and Resume operation
• Electronic Identification- JEDEC 1-byte manufacturer ID and 2-byte device ID- RES command for 1-byte Device ID- REMS command for 1-byte manufacturer ID and 1-byte device ID
• Support Serial Flash Discoverable Parameters (SFDP) mode HARDWARE
FEATURES
• SCLK Input - Serial clock input
• SI/SIO0 - Serial Data Input or Serial Data Input/Output for 2 x I/O read mode and 4 x I/O read mode
• SO/SIO1 - Serial Data Output or Serial Data Input/Output for 2 x I/O read mode and 4 x I/O read mode
• WP#/SIO2 - Hardware write protection or serial data Input/Output for 4 x I/O read mode
• RESET#/SIO3 - Hardware Reset pin or Serial input & Output for 4 x I/O read mode
• PACKAGE- 16-pin SOP (300mil)- 8-land WSON (8x6mm)